2011 Honda Cr-Z Air Filter in Murray, UT

The 2011 Honda CR-Z engine air filter sits inside the airbox in the engine bay, upstream of the intake tube.

This inline 1.5L (1497 cc) four-cylinder uses an enclosed airbox to shield the filter from heat and debris. Open the hood and look for the rectangular housing near the intake snorkel. Our team in Murray can confirm fitment and seal integrity during a quick inspection.

• Engine: 1.5L inline-4, regular unleaded
• Typical location: driver-side/front corner airbox
• Includes gasket check to prevent unmetered air leaks

The 2011 Honda CR-Z cabin air filter is typically located behind the glove box within the HVAC intake path.

Access usually involves lowering or removing the glove box to reach the HVAC filter tray. This filter cleans air entering the cabin, capturing dust and pollen common on Utah roads. We can replace it quickly and verify blower operation before you leave.

• Position: behind glove box, HVAC inlet
• Access: glove box stops/clips disengaged
• Check: airflow direction arrow and tray latch fit

The engine air filter protects the CR-Z’s 1.5L intake for combustion, while the cabin air filter cleans the air that you and your passengers breathe.

The engine filter shields the mass air flow path and cylinders from dust that can reduce power and efficiency. The cabin filter sits in the HVAC system to reduce particulates and odors inside the two-seat hatchback. We install OEM-spec parts for proper fit and filtration.

• Engine filter: in-bay airbox, performance and fuel economy
• Cabin filter: HVAC intake, cabin comfort and odor control
• Both: replaceable elements with specific airflow orientation

Common signs include reduced power, rough idle, and lower fuel economy compared to the CR-Z’s EPA 35 city / 39 highway mpg ratings.

A dirty filter restricts airflow to the 1.5L engine, forcing the intake to work harder and potentially skewing MAF readings. If you notice sluggish acceleration or frequent throttle “hunting,” have us inspect the airbox and filter media in Murray.

• Symptom: noticeable drop in mpg or throttle response
• Check: debris on filter pleats, damaged seal
• Service: quick inspection with complimentary multi-point

Tell-tale signs are weak HVAC airflow, increased window fogging, and a musty odor from the vents.

Because the CR-Z is a compact two-seater, a restricted cabin filter can quickly affect ventilation comfort. Utah’s dust and seasonal pollen can load the media faster. Our team can replace the filter and verify blower and mode-door operation on the same visit.

• Symptom: reduced fan output at higher speeds
• Indicator: lingering odors when A/C starts
• Resolution: new OEM cabin filter, tray and seal check

The engine filter is typically DIY-friendly, while the cabin filter often requires glove box disassembly that many owners prefer a technician to handle.

DIY swaps can work if you follow airflow arrows and seat the gasket properly. At Larry H. Miller Honda Murray, service includes an intake housing check, a visual MAF inspection, and disposal of the old elements. If you’d like help, schedule service online.

• DIY: engine filter lid clips/screws, seal alignment
• Cabin: tray access behind glove box, clip care
• Dealer: OEM-spec parts plus fitment and MAF checks

Yes—Larry H. Miller Honda Murray installs genuine Honda OEM engine and cabin air filters.

Factory parts match the CR-Z’s housing dimensions and filtration requirements, helping preserve performance, safety, and resale value. Our factory-trained Honda technicians use the correct elements and verify airflow direction and sealing surfaces during installation.

• Genuine Honda parts for fit and filtration
• Installed by factory-trained Honda technicians
• Includes intake housing and HVAC tray checks

Follow the Honda Maintenance Minder and your owner’s manual for the official engine air filter replacement interval.

Driving in Utah conditions—dusty roads, winter sand, and wildfire smoke—can load the CR-Z’s filter sooner than light-highway use. We recommend a quick visual check at each oil change and replacement when restriction or contamination is evident. Book a check at our Murray service drive.

• Guidance: Maintenance Minder prompts and manual
• Local factor: dust and seasonal particulates
• Action: inspect at every oil change interval

The 2011 Honda CR-Z pairs a 1.5L inline-4 gasoline engine with a compact hatchback layout, making proper filtration essential. The engine air filter resides in a sealed airbox ahead of the intake tube; the cabin air filter sits behind the glove box within the HVAC intake. OEM Honda filters are engineered to the CR-Z’s airflow and sealing requirements, supporting smooth idle, responsive torque, and consistent fuel economy. Replace elements when inspection reveals dirt loading, damaged pleats, or compromised seals. If you experience reduced power, musty HVAC odor, or weak airflow, request an inspection. Bring your 2011 Honda CR-Z to Larry H. Miller Honda Murray in Murray for OEM-spec filter service — schedule service.

Our air filter service is designed around the 2011 Honda CR-Z’s components and access points. A factory-trained technician will: 1) inspect and replace the engine air filter with a genuine Honda element; 2) inspect and replace the cabin air filter behind the glove box; 3) check the intake housing, clips, and seals for air leaks; and 4) perform a visual mass air flow (MAF) sensor inspection. We confirm airflow direction, re-seat housings to manufacturer torque/clip specs, and road-test for idle quality and HVAC performance. Genuine parts help maintain performance and protect long-term value. To book, use our online schedule service tool or call (801) 719-5451 for assistance.

Visit Larry H. Miller Honda Murray at 5808 South State Street in Murray, Utah, for fast, accurate air filter care on your 2011 Honda CR-Z. Utah driving can expose filters to dust, road sand, and seasonal pollen, which may accelerate filter loading compared to light suburban use. We provide complimentary multi-point inspections, efficient bays, and a modern lounge with free Wi‑Fi, device charging, TV, and refreshments. Same-day availability and a local shuttle make service convenient. Hours are Monday–Friday 7:00 AM – 6:00 PM and Saturday 8:00 AM – 5:00 PM (Sunday closed). For directions and scheduling, schedule service online or call (801) 719-5451; check current service specials before you arrive.