2012 Honda Ridgeline Alignment in Murray, UT

An alignment is worth checking after a major pothole impact, suspension work, or signs that the wheels are no longer tracking correctly. Larry H. Miller Honda Murray can measure the current angles against the manufacturer's specification before recommending an adjustment.

• Check alignment after replacing suspension components.
• Consider an inspection after a significant road impact.
• Use measured results to determine whether adjustment is needed.

Wheels out of alignment scrub the tires as the vehicle rolls, which can create uneven tread wear and alter steering feel. If your 2012 Honda Ridgeline does not travel straight on a flat road, an alignment measurement can identify whether the angles need attention.

• Vehicle pulls to one side on a flat road.
• Steering wheel sits off center while driving straight.
• One edge of a tire wears faster than the other.

The service begins with an inspection of tires, steering, and suspension components that could cause an alignment to move out of specification. Booking with Larry H. Miller Honda Murray gets the current angles measured before an adjustment is recommended.

• Measure camber, caster, and toe on all four wheels.
• Inspect tires, steering, and suspension for related wear.
• Adjust alignment where the suspension allows.

An alignment measurement does not replace a suspension inspection. If a component has excessive wear, correcting the angles alone may not solve the pulling or uneven tire wear. The service team can identify related wear and explain whether an adjustment or additional repair is appropriate.

• Inspect tie rods, ball joints, and struts for wear.
• Check whether suspension movement can hold the corrected angles.
• Review the findings before recommending additional work.

There is no stated alignment interval for this model year, so an inspection can be more useful than scheduling the service automatically. Measuring the angles shows whether the wheels remain within the manufacturer's specification and helps avoid paying for an adjustment that is not needed.

• Consider measurement after suspension or steering work.
• Watch for changes in tire wear or steering position.
• Use the readings to decide whether adjustment is necessary.

The service department measures all four wheel angles and checks related tires, steering, and suspension components. You can schedule service online or contact the dealership at 385-425-4756.

• Service location: 5808 S. State Street, Murray, UT 84107.
• Online scheduling is available through the dealership service page.
• Alignment findings are reviewed before adjustment is recommended.

An alignment check is also useful after a major pothole impact or suspension work. If the angles are within specification, the measurement helps show that an adjustment may not be necessary. If they are out of specification, the service team can identify which correction is appropriate where the suspension allows.

Visit Larry H. Miller Honda Murray at 5808 S. State Street in Murray, UT 84107. Use the service appointment form to request a visit or call 385-425-4756 for assistance.

The inspection includes the components that can affect alignment results, including tires, steering parts, and suspension components. Worn parts may keep the angles from holding, which is why an inspection comes before any recommended adjustment. The service also helps identify whether uneven tread wear reflects an alignment concern or another condition that should be addressed.

Current readings are used to determine whether an adjustment is needed, and before-and-after measurements document the result when correction is performed. Bring your 2012 Honda Ridgeline to Larry H. Miller Honda Murray in Murray for a factory-spec alignment — schedule service.