2013 Honda Fit Air Filter in Murray, UT

The 2013 Honda Fit engine air filter sits in a rectangular airbox inside the engine bay, just behind the front grille on the driver’s side.

This location lets the intake draw cool, clean air before it reaches the throttle body. In Murray’s urban and Wasatch Front driving, debris and dust can collect sooner, so periodic checks help keep performance consistent. Our team can show you the housing clips and advise on safe DIY access if you prefer.

• Access via top-mounted clips/screws on the airbox
• Inspect for debris, oil residue, and housing seal condition
• Verify intake snorkel and clamps are seated after service

The 2013 Honda Fit cabin air filter is located behind the glove box, mounted in the HVAC intake tray.

Access typically requires lowering or removing the glove box to slide out the filter tray. If you drive through spring pollen or dusty corridors along I‑15, the filter may load faster. Our technicians can replace it and confirm the blower motor and recirculation door operate smoothly.

• Open/hinge down glove box to reach filter tray
• Note airflow arrows when inserting new filter
• Check for leaves/pollen buildup in the cowl area

The engine air filter protects the 1.5L inline-4s intake for combustion, while the cabin air filter cleans the air that enters the HVAC system for passengers.

Keeping the engine filter clean supports throttle response and fuel economy; a healthy cabin filter maintains clear airflow and reduces odors. In Murray, dust, road salt, and seasonal pollen affect both components differently. We use OEM-spec filters matched to Hondas design.

• Engine filter: inside engine bay airbox
• Cabin filter: behind glove box in HVAC tray
• Different media and airflow directions by design

Common signs include reduced power, lower fuel economy, rough idle (engine filter), weak HVAC airflow, and musty odors (cabin filter).

Utah dust and pollen can load filters faster, especially with city stop‑and‑go or canyon drives. If your Fit feels sluggish or the fan struggles to clear fog, an inspection is smart. We can confirm filter condition and check the intake path and blower performance.

• Engine: hesitation on acceleration or uneven idle
• Cabin: poor defrost/vent flow, increased fan noise
• Visible dirt/darkening on filter media

The engine air filter is generally DIY-friendly, while the cabin filter may require glove box removal; the dealer adds OEM-spec parts and intake/HVAC checks.

Many owners can safely change the engine filter by unclipping the airbox. The cabin filter involves trim tabs and proper airflow orientation. At Larry H. Miller Honda Murray, we also inspect the intake seals, MAF area, and blower path, then reset the housing correctly.

• DIY: engine filter access via top airbox clips
• Dealer: verifies seals, snorkel, and MAF cleanliness
• OEM Honda filters fitted for correct flow and fit

Yesfactory-trained Honda technicians install genuine OEM-spec filters for the 2013 Honda Fit.

Using Honda-engineered media preserves airflow targets and helps maintain performance and resale value. Our team utilizes state-of-the-art diagnostic tools and follows Honda procedures. This approach supports durability in Murrays mixed dust and pollen conditions.

• Genuine Honda parts for proper fit and seal
• Installed by factory-trained Honda technicians
• Complimentary multi-point inspection included

Most air filter replacements are completed the same day at Larry H. Miller Honda Murray.

We offer same-day service availability and extended hours MondayFriday (7:00 AM6:00 PM) and Saturday (8:00 AM5:00 PM). While you wait, enjoy our remodeled lounge with Wi‑Fi and refreshments. Book a slot online to minimize time on site.

• Same-day availability with online scheduling
• Complimentary multi-point inspection with service
• Free local shuttle to keep your day moving

Key signs are weak HVAC airflow, increased fan noise, and musty or dusty odors from the vents.

In Murray, spring pollen and roadside debris can quickly load the cabin filter behind the glove box. If defrost performance drops or you smell odors with the A/C or heat, the media likely needs replacement. Our team will also clear the cowl intake area.

• Reduced vent flow and slower defogging
• Odors or visible dust when fan speed increases
• Filter media appears gray or debris-laden

The 2013 Honda Fit uses an engine air filter housed in a rectangular airbox to protect the 1.5L inline-4 intake, and a cabin air filter located behind the glove box to clean HVAC airflow. OEM Honda filters are engineered for the Fits airflow and sealing requirements, helping preserve throttle response, fuel economy, and in-cabin comfort. In Utahs dusty summer and pollen-heavy spring, filters can load faster than in mild climates, so periodic inspections are smart. If you notice sluggish acceleration, rough idle, weak vent flow, or musty odors, schedule a check. Bring your 2013 Honda Fit to Larry H. Miller Honda Murray in Murray for OEM-spec filter serviceschedule service.

Service includes targeted checks for both the engine and cabin systems. Our technicians inspect the engine air filter, housing clips, and intake snorkel; replace the filter with an OEM-spec part; and visually verify the MAF sensor area is clean. For the cabin, we lower the glove box as needed, slide out the HVAC filter tray, fit an OEM-spec cabin filter with correct airflow orientation, and confirm blower performance. Every visit includes a complimentary multi-point inspection, clear findings, and disposal of used filters. To keep your day moving, we offer same-day availability, a free local shuttle, and online booking. Ready to go? Schedule service or call (801) 719-5451.

Larry H. Miller Honda Murray serves drivers across the Wasatch Front from our location at 5808 South State Street. Dust from summer construction, winter road treatments, and spring pollen can accelerate filter loading in the 2013 Honda Fit, affecting both performance and HVAC clarity. Our factory-trained Honda technicians provide efficient inspections and OEM-spec replacements, supported by modern diagnostic tools and a comfortable lounge with Wi‑Fi and refreshments. We offer effortless online scheduling and same-day service, with hours Monday–Friday 7:00 AM–6:00 PM and Saturday 8:00 AM–5:00 PM. For directions, navigate to our State Street address in Murray, or call (801) 719-5451. Prefer to plan ahead? Check current service specials and schedule your appointment.