2014 Honda Crosstour Oil Change in Murray, UT

Yes—Larry H. Miller Honda Murray includes a complimentary multi-point inspection and Honda-approved oil and filter with every oil change.

For a 2014 Honda Crosstour, using OEM-spec 0W-20 oil and a genuine Honda filter helps maintain performance and protect long-term value. Our Murray, UT service team documents maintenance for your records, which supports warranty compliance and future resale. Same-day service and online scheduling add convenience without sacrificing quality.

• Honda-approved oil and OEM filter installed
• Complimentary multi-point inspection included
• Service records retained to support warranty compliance

Honda specifies 0W-20 full synthetic oil for the 2014 Honda Crosstour’s 2.4L inline-4 engine.

This viscosity supports reliable cold-start protection and stable high-temperature performance—important for Utah’s seasonal swings. Our team in Murray installs Honda-approved 0W-20 to match OEM standards and helps preserve efficiency and engine longevity. If you tow or drive in dusty or stop-and-go conditions, sticking with OEM-spec full synthetic is especially important.

• Viscosity: 0W-20 full synthetic (OEM-spec)
• Supports fuel economy and cold-start protection
• Meets Honda standards for the 2.4L I-4

The 2014 Honda Crosstour 2.4L typically holds about 4.4 quarts of oil with a filter change.

Capacity can vary slightly with filter choice and drain time, so our technicians measure precisely during service. Using the correct fill prevents over- or under-filling, both of which can affect performance. In Murray, our team verifies level after a short run cycle to ensure accuracy before you leave.

• Approximate capacity: 4.4 quarts with filter
• Level verified warm and on level ground
• Filled with OEM-spec 0W-20 full synthetic

Follow Honda’s Maintenance Minder; in typical driving this often equates to roughly 7,500 miles, and sooner under severe-duty conditions.

Utah driving with frequent short trips, dust, towing, or extended idling may trigger earlier service. Our Murray technicians read your Maintenance Minder codes and reset them after service. Staying on this schedule supports warranty compliance and long-term engine health.

• Maintenance Minder provides the exact interval
• Severe duty may shorten intervals
• Service includes Minder reset and record

Most oil changes are completed the same day during service hours (7:00 AM–6:00 PM Mon–Fri, 8:00 AM–5:00 PM Sat).

Plan to leave your 2014 Honda Crosstour with us briefly while we perform the oil and filter change plus a complimentary multi-point inspection. You can relax in our modern lounge or use the free local shuttle. To minimize wait time, please schedule service online.

• Same-day availability in most cases
• Complimentary lounge amenities and Wi‑Fi
• Online scheduling to reserve a time

Missing oil changes per the Maintenance Minder can jeopardize warranty coverage; keep dated service records.

Honda expects oil changes to follow the OEM schedule and specification. Service documentation from a qualified facility—like Larry H. Miller Honda Murray—helps demonstrate compliance if a warranty concern arises. We store your records and use OEM-spec oil and filters.

• Follow Maintenance Minder intervals
• Use OEM-spec 0W-20 and a Honda filter
• Retain receipts and records for proof

Yes—current oil change offers are posted on our service specials page.

Before you book, check our Murray, UT service specials for savings on your 2014 Honda Crosstour’s maintenance. Offers change regularly and may include oil service bundles. Combine online scheduling with available discounts to plan a convenient visit.

• See live deals on the service specials page
• Offers rotate—check before you schedule
• OEM-spec oil and filter included with service

Honda recommends 0W-20 full synthetic, which provides the best oxidation stability and cold-flow performance for the 2014 Crosstour.

Conventional oil costs less but breaks down sooner under heat and stress. Synthetic blends improve stability, while full synthetics deliver the most consistent protection—valuable in Utah’s temperature swings and stop-and-go traffic. Our team installs Honda-approved 0W-20 to match OEM specs.

• OEM recommendation: 0W-20 full synthetic
• Full synthetic resists breakdown and sludge
• Better cold-start flow in winter conditions

Your service starts with a careful drain of the old oil and replacement of the drain washer. We then install a genuine Honda oil filter and fill your 2014 Honda Crosstour with OEM-spec 0W-20 full synthetic to the correct level. A complimentary multi-point inspection follows, checking tires, brakes, fluids, belts, and visible leaks. We top off fluids, set tire pressures to spec, reset the Maintenance Minder, and road-test if needed. Service documentation is stored for your records to support warranty compliance. Check our current service specials before you schedule service, and call our team at (801) 719-5451 with any questions.

The 2014 Honda Crosstour with the 2.4L inline-4 is designed for 0W-20 full synthetic engine oil to meet Honda performance and efficiency targets. Capacity is approximately 4.4 quarts with a filter change, though our technicians verify the level after a warm run cycle for precision. Follow the vehicle’s Maintenance Minder for normal-service intervals; severe-duty driving (frequent short trips, dust, towing, or extended idling) may require earlier changes. A genuine Honda oil filter is used to maintain proper filtration and anti-drainback performance. Bring your 2014 Honda Crosstour to Larry H. Miller Honda Murray in Murray for an OEM-spec oil change — schedule service.

Larry H. Miller Honda Murray services the 2014 Honda Crosstour with OEM procedures tailored to Utah’s climate. Cold winter starts demand reliable 0W-20 flow, while summer heat and I-15 stop-and-go traffic increase thermal load—both are handled well by Honda-approved full synthetic. If you tow up to the Crosstour’s rated 1,000 lbs. or drive on dusty frontage roads, expect earlier Maintenance Minder prompts. Same-day service, online scheduling, and a recently remodeled lounge keep the visit efficient. We’re conveniently located at 5808 South State Street in Murray, Utah—use our schedule service tool or call (801) 719-5451 for directions and appointment assistance.