2022 Honda Cr-V-Hybrid Alignment in Murray, UT

Alignment timing depends on driving conditions and the vehicle's symptoms. Routine tire service does not always require an alignment, but a major impact or suspension repair can change wheel angles. A measurement at Larry H. Miller Honda Murray shows whether adjustment is needed.

• Consider an alignment after a major pothole impact.
• Check alignment after suspension work.
• Use tire wear and steering behavior as warning signs.

Wheels out of alignment scrub the tires as the vehicle rolls, which can wear tread unevenly. A vehicle may also drift on a flat road or require constant steering correction. The alignment service includes inspection of tires, steering, and suspension components that could affect the result.

• Look for wear concentrated on one tire edge.
• Notice whether the vehicle pulls on a flat road.
• Check whether the steering wheel sits off center.

The technician begins by inspecting the tires, steering, and suspension for wear that could hold an alignment out of specification. Current angles are measured against the factory specification before any adjustment is recommended. This process helps distinguish an alignment issue from a worn component.

• Measure camber, caster, and toe on all four wheels.
• Inspect tires, steering, and suspension components.
• Adjust angles where the suspension allows.

A technician should inspect suspension and steering components before completing an adjustment. If a component has excessive wear, correcting wheel angles alone may not resolve pulling or uneven tire wear. Larry H. Miller Honda Murray can explain the inspection findings before additional work is authorized.

• Inspect tie rods for wear.
• Check ball joints and struts.
• Confirm whether the suspension can hold factory-spec angles.

Alignment service becomes more useful after symptoms, a major pothole impact, suspension work, or tire wear on one edge. Measuring the current angles gives you information before paying for an adjustment. This approach helps determine whether the vehicle is within the manufacturer's specification.

• Review tire wear before scheduling an adjustment.
• Consider measurement after suspension component replacement.
• Use steering behavior to identify a change.

The service is available at 5808 S. State Street in Murray, Utah. The measurement helps show whether camber, caster, or toe requires adjustment and whether tire or suspension wear may affect the result. You can schedule service online or call (801) 719-5451.

• Visit the service center at 5808 S. State Street.
• Measure all four wheel angles.
• Call the service department at (801) 719-5451.

For local drivers, pothole impacts, road construction, and uneven road surfaces can change steering feel or tire wear. A measurement provides a fact-based check before adjustment. The service department offers online appointment scheduling and can be reached directly at (801) 719-5451.

Visit Larry H. Miller Honda Murray at 5808 S. State Street, Murray, UT 84107, or schedule service online for your 2022 Honda Cr-V-Hybrid.

The technician measures the front and rear positions independently where applicable, then adjusts the angles where the suspension allows. Tire, steering, and suspension wear are inspected because loose or worn components can keep an alignment from holding. Uneven tread wear, pulling, and an off-center steering wheel are useful issue callouts for this service.

Bring your 2022 Honda Cr-V-Hybrid to Larry H. Miller Honda Murray in Murray for a factory-spec alignment — schedule service.